Loading ...
Loading ...
Loading ...
5
6. Keep the spreader level with the ground and maintain a
steady pace while pushing it.
NOTE: You may find that you need to adjust the feed
control depending on your walking speed.
7. To ensure even coverage, spread the material in parallel
lines as shown. Slightly overlap previously covered ground
so you do not miss any spots (Fig. 9).
8. Always move the control lever to the closed position before
turning, stopping or reversing. This reduces waste and
avoids oversaturating and thereby damaging your lawn.
9. If material is accidentally deposited too heavily on a
particular area, soak the area thoroughly with a garden
hose to prevent it from burning your lawn.
Care + Maintenance
• After each use, clear out any remaining material from the
hopper and the impeller. Then, rinse the spreader and leave
it to dry.
• The recommended pressure for the pneumatic tires is 20
PSI.
• Periodically inspect all fasteners and tighten if necessary.
• Use a grease gun to add additional grease into the grease
fittings on the wheel bearings.
• Check for worn or damaged parts. Replace worn parts as
necessary or contact the SnowJoe
®
+ SunJoe
®
customer
service center at 1‑866‑SNOWJOE (1‑866‑766‑9563) for
repair before using the product again.
Storage
• Never store the spreader with material remaining in the
hopper.
• Store indoors.
Fig. 9
Service + Support
If your SunJoe
®
SJ‑WBS70 70‑lb Multi‑Purpose Walk‑Behind
Spreader requires service or maintenance, please call
1‑866‑SNOWJOE (1‑866‑766‑9563) for assistance.
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the label
located on the housing of the unit. Copy these numbers into the
space provided below.
Record the following numbers from the housing or
registration card of your new product:
Model #:
Serial #:
S J ‑ W B S 7 0
Loading ...
Loading ...
Loading ...