Loading ...
Loading ...
Loading ...
LF
LF
LF
LF
I
:
LF$
Â
Ĉ
7
LF$
$
$
~
10
Care/Cleaning
ʑ
Machine housing, control panel
Remove detergent residue immediately.
Wipe with a soft, damp cloth.
Do not clean the appliance with a water jet.
Clean the detergent drawer ...
... if it contains detergent or fabric softener residue.
1. Pull out, depress insert, take out drawer all the way.
2. Take out insert: using your finger, press insert upwards.
3. Clean detergent dispenser and insert with water and a brush and dry.
4. Attach insert and lock into position (push cylinder onto guide pin).
5. Insert detergent drawer.
Leave detergent drawer open so that residual water can evaporate.
ʑ
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine-free cleaning agent, not steel wool.
ʑ
Descaling No washing in the machine!
Not required if detergent dosed correctly. However, if this does occur, follow the instructions
of the descaling agent manufacturer. Suitable descalers can be purchased on our website
or from customer service. aPage 13
Information on the display panel depending on model
§jDoor can be opened.
ǯDoor cannot be opened due to high temperature inside aWait for the temperature
to drop
Door cannot be opened due to high water level a Drain the water (e.g. select
Spin/Empty >programme).
§: ³ÅTurn on tap (cold water) fully;
Supply hose kinked/jammed, water pressure too low. aPage 11:Maintenance,
Filter blocked in water inlet hose
§: ³µDrain pump blocked aPage 11: Maintenance, Drain pump blocked
Drainage hose/outlet pipe blocked aPage 11: Maintenance, Drainage hose on the
siphon blocked
§: ´Water in the base pan, appliance leaking. Turn off the tap. Call customer service!
'
If childproof lock active. Deactivate
a
Page 5
ª
Flasches if too much detergent is used.
a
Page 12
Other
displays
Switch off appliance, wait 5 seconds and switch on again. If the display is indicated
again, call customer service.
a
Page 13
Risk of electric shock! Pull out the mains plug!
Risk of explosion! No solvents!
11
Risk of scalding!
Allow detergent solution to cool down!
Turn off the tap!
Maintenance
Drain pump blocked
Set programme selector to  Off, pull out the mains plug.
1. Open service flap.
2. Take the drainage hose out of the holder.
3. Remove sealing cap, allow detergent solution to flow out. Have a suitable
container ready.
Push up the closing cap and place the drain hose back in its holder.
4. Carefully unscrew the pump cover (Caution! residual water).
Clean the interior, pump cover thread and pump housing (fan impeller
in the detergent-solution pump must rotate).
5. Reinsert and screw on pump cover. Handle should be vertical.
6. Close the service flap.
To prevent unused detergent from flowing into the outlet during the next
wash:
Pour 1 litre of water into dispenser II and start the
Spin/Empty
>
programme.
Drainage hose on the siphon blocked
Set programme selector to  Off, pull out the mains plug.
1. Loosen hose clip, carefully remove drainage hose.
(Caution! Residual water.)
2. Clean drainage hose and siphon spigot.
3. Re-attach drainage hose and secure connection point with hose clip.
Filter blocked in water inlet hose
Risk of electric shock!
Do not immerse Aqua-Stop safety device in water (contains electric valve).
Release water pressure in the supply hose:
1. Turn off the tap!
2. Select any programme (except Spin/Empty >).
3. Press $Start/Reload button. Leave programme for approx. 40 seconds.
4. Set programme selector to ÂOff. Pull out the mains plug.
Clean the filter:
5. Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:
remove hose from the rear of the appliance.
Take out filter with pliers and clean.
6. Connect the hose and check for leaks.
ʑ
ʑ
$
a
ʑ
a
a
a
ʑ
$
ʑ
a
a
ʑ
ʑ
a
ʑ
ʑ
ʑ
0
a
ʑ
LF
ʑ
ª
ʑ
a
a
ʑ
ʑ
ʑ
Â
a
Â
a
ʑ
a
ʑ
ʑ
ʑ
Loading ...