Loading ...
Loading ...
Loading ...
49-1000105 Rev. 432
Problem Possible Causes What To Do
Water on kitchen floor or on
bottom of freezer
Cubes jammed in chute. Poke ice through with a wooden spoon.
Hot air from bottom of
refrigerator
Normal air flow cooling motor. In the
refrigeration process, it is normal that
heat be expelled in the area under the
refrigerator. Some floor coverings are
sensitive and will discolor at these
normal and safe temperatures.
Refrigerator never shuts off but
WKHWHPSHUDWXUHVDUH2.
Adaptive defrost keeps compressor
running during door openings.
This is normal. The refrigerator will cycle off after the
door remains closed for 2 hours.
Refrigerator is beeping Door is open. Close door.
Door not closing properly Door gasket on hinge side sticking or
folding over.
Apply petroleum jelly on face of gasket
Actual temperature not equal to
Set temperature
Unit just plugged in. Allow 24 hours for system to stabilize
Door open for too long Allow 24 hours for system to stabilize
Warm food added to refrigerator Allow 24 hours for system to stabilize
Defrost cycle is in process Allow 24 hours for system to stabilize
Troubleshooting Tips... Before you call for service
TROUBLESHOOTING TIPS
Appliance Communication (on some models)
REGULATORY INFORMATION
FCC/IC Compliance Statement:
This device complies with Part 15 of the FCC Rules. This device contains license-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development, Canada’s license-exempt RSS(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
Labelling: Changes or modifications to this unit not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
ConnectPlus module only (or similar communication module)
RF Exposure - This device is only authorized for use in a mobile application. At least 20 cm of separation distance
between the ConnectPlus device and the user’s body must be maintained at all times.
Loading ...
Loading ...
Loading ...