Loading ...
Loading ...
Loading ...
17
3-in-1 Cordless Lawn Mower EN
TROUBLE SHOOTING
Problem Solution
1. Mower doesn’t run when
switch lever is activated.
A. Check to make sure safety key has been installed and is fully seated and
that button on switch housing is being completely pushed.
B. Release switch lever to turn mower off. Remove safety key, turn mower
over and check that blade is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light
to come on.
2. Motor stops while mowing. A. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return to an
authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light
to come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raise the cut height. Or both.
3. Mower runs but cutting
performance is unsatisfactory,
or does not cut entire lawn.
A. Has battery been fully charged? Plug in charger and wait for green
light to come on.”
B. Release switch lever to turn mower off. Remove safety key. Turn
mower over and check: Blade for sharpness - Keep blade sharp. Deck and
discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise
cutting height
4. Mower is too hard to push. A. Raise cutting height to reduce deck drag on grass. Check each wheel
for free rotation.
5. Mower is abnormally noisy
and vibrates.
A. Release switch lever to turn mower off. Remove safety key. Turn mower
on side and check blade to ensure it has not been bent or damaged. If
blade is damaged, replace with a replacement blade. If the underside of the
deck is damaged return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release switch lever to turn mower off, remove safety key and remove
blade. Rotate blade 180 degrees and retighten. If mower still vibrates,
return the mower to an authorized service center.
6. Battery charger LED’s not on. A. Check plug connection.
B. Replace charger.
7. Battery charger LED does not
flip to green.
A. Battery needs to be diagnosed. Take to authorized service center.
8. Mower not picking up
clippings with the Grass
Collection Bag.
A. Remove mulch plate when bagging.
B. Chute clogged. Release switch lever to turn mower off. Remove safety
key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut.
D. Bag full. Empty bag more often.
9. When mulching there are
clippings visible.
A. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
10. Low or diminished
run-time after many uses
A. Return to Authorized Service location - may need new battery.
11. The battery charger LED
flashes red and the battery
can’t be charged.
A. The battery overheats after continuous use. Remove battery from the
charger and allow it to cool to 42
o
C or less.