Loading ...
Loading ...
Loading ...
27
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation
Match lighting
If the burner will not light after several attempts, then
the burner can be match lit. If you have attempted to
light the burner with the igniter, allow five minutes for
any accumulated gas to dissipate.
U-burners
Keep your face as far away from the grill as possible
while manually igniting. To manually ignite, light a butane
lighter before pushing and turning the control knob to
"SEAR" of the rightmost burner. Wait 2 seconds for gas to
prime manual ignition tube, then move lighter to 10mm in
front and a little below the hole located on the top right
of the burner (Fig. 16a). If the burner does not light in
four to five seconds, turn knob off, wait five minutes and
try again.
Sear burner
Keep your face as far away from the grill as possible. To
light, place a lit butane lighter or match (match holder
provided and located in drip tray) into the gap between
the grates until the flame touches the mesh. (Fig.16b).
Push and turn the knob to “MAX”. If the burner does
not light in four to five seconds, turn knob off, wait five
minutes and try again.
Improper lighting procedures can cause the LP tank flow control to activate resulting in reduced heat
output. If this is suspected the flow control will need to be reset.
Refer to the Troubleshooting section of the user guide if you encounter any difficulties lighting your grill.
See the Quick Start Guide for how to use the griddle.
1 All knobs must be in the
OFF position.
2 Attach regulator hose
assembly to the tank.
3 Open the LP tank valve.
(Two full turns min).
Resetting the flow control
Grill lighting instructions
IMPORTANT!
• Open the grill hood before lighting. Turn all knobs to “OFF”. Turn the main gas supply on. If you
smell gas, shut-off gas supply and call for customer care. Only light one burner at a time.
Pushing in on the burner knob will activate the Grill Igniter, and then turning the knob from the “OFF”
position will allow the flow of gas to the burner.
The Grill Igniter will glow orange, but there will be no clicking sound during ignition.
Push in and hold the
burner knob for two seconds. Verify that the Grill ignitor is glowing. Turn the knob counterclockwise.
Release when the burner lights. If the burner does not light in four to five seconds, turn knob "OFF"
and wait five minutes before trying again so any accumulated gas may dissipate.
FIG. 16a
FIG. 16b
USING THE GRILL
Lighting Instructions
Loading ...
Loading ...
Loading ...