Loading ...
Loading ...
Loading ...
en Installation instructions
20
1.
Make a cut-out in the worktop, depending on the in-
stallation position.
The angle between the cut surface and the worktop
must be 90°.
2.
Ensure that the worktop has sufficient load-bearing
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
4.
Remove any shavings.
5.
Depending on the installation position, remove the
back panel of the fitted unit.
Preparing the appliance
WARNING‒Risk of injury!
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
1.
Place the appliance on a soft surface and remove
the transit bolt.
2.
Stick the seal in the designated groove and trim
it .
3.
Screw the cover plate in tightly, depending on the
installation situation.
Installing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
Note:To protect the cables, do not remove the transit
bolt yet.
1.
Lift the appliance by the short sides and align the
front of the appliance with the hob.
2.
Pull the cable connection into the strain relief
and
remove the transit bolt .
3.
Note:To ensure that the appliance is not yet fully in-
serted into the cut-out, place a slat below the short
side of the appliance in each case.
Insert the appliance into the cut-out in the worktop
from above.
Insert the appliance evenly so that it is not tilted.
4.
Mark the cut-out for the pipework:
Loading ...
Loading ...
Loading ...