Loading ...
Loading ...
Loading ...
6
From the Garmin Express application, click Add a Device.
The Garmin Express software detects your device.
7
Click Add Device.
8
Follow the on-screen instructions to register your device and
add it to the Garmin Express software.
When setup is complete, the Garmin Express software
searches for software updates for your device.
9
Select an option:
• To install all available updates, click Install All.
• To install a single update, click View Details, and select
an update.
10
When the software update is complete, disconnect the device
from your computer.
11
Reinstall the battery door.
The device installs the software update.
Connecting the Device to Your Computer
Before you can connect the device to your computer, you may
need to remove optional mount accessories.
1
Using a 5/64 inch hex wrench, loosen the four screws
securing the battery door.
2
Remove the battery door, and set it aside.
NOTE: Do not remove the batteries.
3
Plug the small end of the USB cable into the USB port on
the device.
4
Plug the large end of the USB cable into a computer USB
port.
5
If the bow sight is turned off, press to turn on the device.
The bow sight enters USB mass storage mode.
Device Care
NOTICE
Avoid extreme shock and harsh treatment, because it can
degrade the life of the product.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can
damage plastic components and finishes.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
Cleaning the Device
1
Dampen a soft, clean, lint-free cloth with fresh water.
2
Gently wipe the device.
Getting More Information
You can find more information about this product on the Garmin
website.
• Go to support.garmin.com.
• Go to www.garmin.com/outdoor.
• Go to http://buy.garmin.com, or contact your Garmin dealer
for information about optional accessories and replacement
parts.
Troubleshooting
The point of impact moves between shots
There are several factors that can cause variations in the point
of impact.
• Verify the screws that connect the mount to the riser are
tightened to the maximum torque specification of 6.7 N-m (60
lbf-in) and the mount cannot be moved on the bow.
NOTE: Do not exceed the bow manufacturer's recommended
torque values.
• Verify each adjustment point on the mount is tightened to the
maximum torque specification of 2.2 N-m (20 lbf-in).
• Verify you are using the correct arrow profile for the arrow
you are using (A1i models only).
• Range your shots consistently at full draw or at rest.
• Inspect your bow and confirm all components are in good
working condition.
• Always use consistent form when shooting a bow. Variations
in stance and peep sight placement can affect accuracy.
My device only displays fixed pins
When the batteries are low or do not meet the minimum power
requirements for the laser rangefinder, the device allows only
fixed pin sighting.
• Verify the battery level of the batteries you have installed.
• Verify you are using AAA lithium batteries.
Tips for Consistent Ranging
If you are a target shooter, consistent ranging can help to
increase your accuracy.
• Use the rangefinder consistently while you are using the
same form (at full draw or at rest).
• Enable decimal precision (Units Settings, page 7).
• Verify you are aiming the reticle at the target when you
release the ranging trigger.
Resetting the Device
If the device stops responding, you may need to reset it. This
does not erase any of your saved data or settings.
1
Hold for 12 seconds.
The device turns off.
2
Hold for one second to turn on the device.
8 Device Information
Loading ...
Loading ...