Loading ...
Loading ...
Loading ...
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Control pads for Sensor Cooking, The oven door was opened and closed without initiating a cooking cycle
One-Touch Cooking, and Defrost within three minutes. Touch CLEAR/OFF to resume normal pad operation.
will not operate.
Microwave oven light does not If one of those situation appear please check the electrical outlet, fuse and/or
come on. Cooling fan does not circuit breaker, if they are functioning properly, contact your nearest Electrolux
work.Turntable does not rotate. Authorized Servicer. A microwave oven should never be servicer by a "do-it-
yourself" repair person.
Water in a cup in microwave does If this situation appears please check the electrical outlet, fuse and/or circuit
not warm. breaker. If they are functioning properly, contact your nearest Electrolux
Authorized Servicer. A microwave oven should never be servicer by a "do-it-
yourself" repair person.
Time appearing in the display is Please check Demonstration Mode on page 16 and cancel.
counting down very rapidly.
Waft Oven Control Beeps and Electronic control has detected a fault condition. Press CLEAR/OFF to clear
Displays any F code error (example the display and stop the beeping. Reprogram the oven. if a fault reoccurs,
Ff 1). record the fault number. Press CLEAR/OFF and call Electrolux or another
qualified servicer.
-dr= is displayed. The door was left open and controls set for self-cleaning cycle. Close the door
and push CLEAR/OFF pad.
Installation. Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
Entire Wall oven does not operate.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display will flash. The oven cannot be programmed until
the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Electrolux or another qualified servicer.
Service wiring not complete. Contact Electrolux or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls
to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call Electrolux or another qualified servicer.
42
Loading ...
Loading ...