Loading ...
Loading ...
Loading ...
15
Water Level Touchpad
Choose the water level by pressing the
“Water Level” touchpad.
Use only the amount of water you need for
the wash load.
Please refer the to program table on page
12.
Flood diagnostic is explained on
page 31. You should refer to this if
you have water pouring onto the
floor. The display will show “ ”
and you will hear rapid short beeps
continuously to remind you about
this problem.
Temp Touchpad
For each wash program your washing
machine automatically selects a suitable
fill water temperature. If you want to use a
different wash water temperature, press
the Temperature button repeatedly.
The temperature of warm water will
depend on the temperature and pressure
of your hot and cold water supplies. The
recommended temperature for warm is
35°C.
You have four temperatures to choose
from Hot, Warm, Normal and Cold.
The water temp lights will tell you the
temperature for each press of the button.
Always check your label for the washing
temperature symbols which the
International Care Labelling Code now
uses
If you have a cold water connection
ONLY and the hot inlet valve is
capped off (refer installation
instructions) you must select Cold
washes only.
You can adjust the flow rate of the water
supplies to adjust the Warm temperature.
All rinse water temperatures are cold.
Cold,Warm, Hot.
Pressing the Rinse touchpad to choose
the rinse type for your wash load. For
most washes, the machine automatically
fills the full tub of water for a rinse.
Rinse Touchpad
There are four rinses to choose from
Extra, Regular, Fast and Eco to remove
the detergent from the clothes.
Extra rinse - 2 rinses cycles.
Regular rinse - 1 rinse cycle.
Fast rinse - Spraying water 3 rinses
cycles.
Eco - Spraying water 4 rinses cycles.
When Eco rinse is used, rinse water is
sprayed into the washbowl in pulses.
After each pulse the washbowl will spin
to remove detergent laden water from
the clothes.
How does Eco Rinse work?
The machine will go through a series of
maximum 4 pulses spray and short spin
cycles in this manner, depending on
program selection, followed by a final
long spin that removes the water from the
clothes to complete the full wash
program.
Components in the washing machine are
designed to be used with water no hotter
than 60°C. If your water supply is too hot,
you should have a temperature limiting
valve fitted by a qualified plumber.
Mixed water temperatures in table below
are based on hot water supply of 60 ºC and
cold water supply of 20 ºC
Water Temperature
Temp.
Hot
75% 25% 50 to 55 ˚C
35 to 40 ˚C
20 to 25 ˚C
40%
10%
0%
60%
90%
100%
Warm
Normal
Cold
Hot & Cold water usage propertion
Hot
Valve
Cold
Valve
Temp after mixing water
3.4 Options
Loading ...
Loading ...
Loading ...