Loading ...
Loading ...
Loading ...
Owner’s Manual for Power Station 7
Section 3 Operation
Operation and Use Questions
Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) with questions
or concerns about equipment operation and
maintenance.
General Use
Powering ON the Power Station
Press and hold the ON/OFF button to turn ON
the Power Station. The ON/OFF button will
illuminate, and the LCD display will turn ON.
NOTE: The Power Station will automatically
shut down after 60 minutes of idle operation to
conserve the battery.
Press and hold the ON/OFF button again to
turn off the Power Station.
LCD Display
The LCD display automatically turns ON when
the Power Station is turned ON. Once the
Power Station is ON, the display can be tog-
gled ON and OFF by pressing the Display But-
ton.
NOTE: The Power Station display will enter
sleep mode after 10 minutes of idle operation.
LED Light
With the Power Station powered ON, press
the LED button once to turn ON the low flood
light. Press the LED Button again to turn ON
the high flood light. Press the LED Button
again to turn off the light.
Wireless Charger
With the Power Station powered ON, press
the DC Button to turn ON the wireless charger.
NOTE: Ensure the device is centered on the
wireless charging pad. Wireless charger may
not be compatible with certain devices or
cases on devices.
AC Output
With the Power Station powered ON, press
the AC Button to use the 120V AC recepta-
cles. The AC Button will illuminate, and the AC
icon will appear on the display.
NOTE: If the AC Button is flashing, press and
hold the AC Button to reset the circuit. See
Troubleshooting if the flashing persists.
DC Output
With the Power Station powered ON, press
the DC Button to use the USB’s, 12V car
adapter and wireless charger. The DC Button
will illuminate, and the DC icon will appear on
the display.
NOTE: If the DC Button is flashing, press and
hold the DC Button to reset the circuit. See
Troubleshooting if the flashing persists.
Using the Power Station
(Discharging)
Starting the Power Station
NOTE: If using only one, or all three AC
receptacle(s), the load must not exceed 13.3A
current, 1600 watts of power.
1. Confirm the device or equipment requiring
power is OFF.
2. Press and hold ON/OFF button for three
(3) seconds to turn unit ON.
3. Connect equipment.
– AC Power - Turn ON AC power switch.
– DC Power (USB/vehicle charging) -
Turn ON DC power switch.
NOTE: Power Station will automatically turn
off after 60 minutes if not in use.
Charging the Power Station
IMPORTANT NOTE: Always use the
charging cord(s) supplied with the unit.
NOTE: The ambient temperature for product
use should be between 0 °C to 40 °C (32 °F to
104 °F).
Place the Power Station on a clean, dry, level
surface.
The Power Station can be charged three (3)
separate ways.
1. See Figure 3-1. AC Power Supply - Insert
AC charging cord from the AC charging
port to the wall electrical outlet.
Figure 3-1. AC Wall Charging
2. See Figure 3-2. Solar Panels - Insert DC
charging cord from the solar panel into the
DC charger port.
NOTE: Charging time is dependent on the
solar panel power and light intensity.
(000752)
WARNING
Injury and equipment damage. The use of non-Generac
equipment could result in unit damage, death or serious
injury.
013906
Loading ...
Loading ...
Loading ...