Loading ...
Loading ...
Loading ...
OVEN PROBLEM PROBLEM SOLVING STEPS
The oven mode or temperature selected or the numbers The knob was turned too rapidly, Turn knob slower until
selected do not appear in the display correct wording or temperature appears. Review manual
instructions when setting clock, timer, or Self-Clean.
Oven door is locked and wi[[ not release, even after cooling Turn the oven off atthe circuit breaker and wait 5 minutes.
Turn breaker back on. The oven should reset itself and
will be operable.
Oven is not heating Check the circuit breaker or fuse box to your house. Ha ke
sure there is proper electrical power to the oven. Hake
sure the oven temperature has been selected.
Oven is not cooking evenly Check oven calibration. Adjust calibration if necessary
(see Oven Temperature Offset). Refer to cooking charts
for recommended rack position. Always reduce recipe
temperature by 25°F when baking with Convection Bake
mode.
Oven temperature is too hot or too cold The oven thermostat needs adjustment. See Oven
Temperature Offset,
Oven light is not working properly Replace or reinsert the light bulb if loose or defective,
Touching the bulb with fingers may cause the bulb to
burn out,
Oven light stays on Check for obstruction in oven door, Check to see if hinge
is bent,
Cannot remove lens cover on light There may be a soil build=up around the lens cover, Wipe
lens cover area with a clean dry towel prior to attempting
to remove the lens cover,
Oven will not SeIFC[ean properly
Clock and timer are not working properly
Porcelain chips
"F" and a number appears in display and control beeps
Allow the oven to cool before running SeIFClean. Always
wipe out loose soils or heavy spillovers before running
SelfiClean. If oven is badly soiled, set oven for a five-
hour Self-Clean. See Preparing the Oven to SeiFClean.
Hake sure there is proper electrical power to the oven.
See the Clock and Timer sections.
When oven racks are removed and replaced, always tilt
racks upward and do not force them to avoid chipping the
porcelain.
This is a fault code. If a"F" code flashes, press Offto clear
the display and stop beeping. Reset oven if necessary. If
fault code remains and beep continues, record fault code,
cancel oven and call authorized servicer.
With a new range there is strong odor when oven is This is normal with a new range and will disappear after
turned on a few uses. Operating the self-dean cycle will also"burn-
off" the smell more quickly.
Page 31
Loading ...
Loading ...