Loading ...
Loading ...
Loading ...
en Installation instructions
28
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING‒Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
▶ If the power cord is too short, contact cus-
tomer service.
19.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. The minimum installation height is
850mm.
Ventilation slots and intake openings must not be
covered.
19.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
WARNING‒Danger: Magnetism!
The appliance contains permanent magnets. These
may affect electronic implants, e.g. heart pacemakers
or insulin pumps.
▶ Persons with electronic implants must stay at least
10cm away from the appliance.
WARNING‒Risk of fire!
The use of multi-plugs, multiple connectors or exten-
sion cables may cause a fire.
▶ Never use multi-plugs, multiple connectors or exten-
sion cables.
¡ The appliance is fitted with a plug and must only be
connected to a protective contact socket which has
been correctly installed.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to local regulations.
¡ A socket must only be installed by a qualified elec-
trician, and in accordance with the appropriate regu-
lations.
¡ If the plug is no longer accessible following installa-
tion, an all-pole isolating switch with a contact dis-
tance of at least 3mm must be present.
19.5 Installation in an upper cabinet
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
Remove the feet.
19.6 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
Loading ...
Loading ...
Loading ...