Loading ...
Loading ...
Loading ...
TO REPLACE DRIVE BELT
7. Position the blade adapter on the en-
gine crankshaft. Be sure key in adapter
and crankshaft keyway are aligned;
and that the drive belt is inside the tabs
of the belt retainer.
8. Route the other end of the new drive
belt through hole in housing.
9. Return mower to upright position.
10. Install new belt on gearcase pulley.
11. Reinstall belt keeper and spring.
12. Reinstall drive cover.
NOTE: Always use factory approved belt
to assure proper fit and long life.
13. Turn lawn mower on its side with air
filter and carburetor down.
14. Reinstall blade and blade adapter.
Blade adapter Key Crankshaft
Lockwasher
Blade
))
/ /
Blade Hardenec
bolt washer
Trailing edge Crankshaft retainer
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Husqvarna
or other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due
to suspected carburetor problems, take
your lawn mower to a Husqvarna or other
qualified service center for repair and/or
adjustment.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Husqvarna or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
TO ADJUST HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to height that
suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
Hi( Handle pin
SQUEEZE
Handle
bracket
16
Loading ...
Loading ...
Loading ...