Ancona AN1508 User Manual

Loading ...

— 14 —

Installation

STEP 14

Connect to AC

• ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2in.

(851 mm) from where the cord exits on the hood.

• SEE IMPORTANT INSTRUCTIONS ON THIS PAGE.

3-Pronged Plug

Ground Plug

3-Prong Receptacle

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat

thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp

circuit, fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged

into an outlet that is properly installed and grounded.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

STEP 13

Install Chimney

• Place chimney on top of the main housing.

• Remove the protective coating from the upper

chimney. Carefully slide the upper chimney down

into the lower chimney.

• Use two screws E to x the two chimneys together

with the lower chimney bracket, make sure upper

chimney is moving freely. (See Figure #6)

• Screw the upper chimney to the upper mounting

bracket with two E screws. (See Figure # 7)

Fig. #6 Fig. #7

Inner Chimney Bracket

Loading ...

Ancona AN1508 36 Inch Stainless Steel Convertible Chimney Style Wall Mount Hood