Loading ...
Loading ...
Loading ...
5
Dwg Name: VDV500-820E-1390411ART
Dwg No: 1390411 Rev: B
Pkg Dwg Ref: 1790 ECO No: 041011
Finish Coat Requirements: N/A
OPERATING INSTRUCTIONS
VERIFYING TONED PAIRS (FIG. 2)
1. To verify you have found the toned pair, connect the Toner-Pro's ABN Test Clips
T14
or RJ11 Test Plug
T13
to
one end of the cable and initiate a tone.
2. On the other end of the cable, remove approximately 2 mm (3/32") of the outer jacket of each of the wires
believed to be the toned pair.
3. Insert the wire connected to the red ABN Test Clip
T14
to the
"+" (Positive) Terminal
P12
,
and the wire curently
in the black ABN Test Clip
T14
to the
"-" (Negative) Terminal
P11
. To access the terminals, press their respective
Terminal Release buttons
P13
, insert the wire(s) and release (FIG. 2). The
Verification Indicator
P14
will
illuminate when the correct pair is inserted.
TRACING NON-PAIRED WIRES (FIG. 3)
1. Connect the Toner-Pro’s red ABN Test Clip
T14
to the wire to be traced.
2. Connect the black ABN Test Clip
T14
to another wire in the cable, but preferably not in the same pair (connect
to the ground, if available). When tracing a shielded cable, connect the red ABN Test Clip to the outer shield,
and the black ABN Test Clip to the center conductor or ground.
3. Turn Toner-Pro on by pressing the Power On/Off button
T9
.
4. Check the ‘CONT’ Indicator
T4
. If it is illuminated green, you may proceed.
5. Turn the Probe-Pro on by pressing the Power On/Off button
P5
.
6. Select the preferred tone setting using the
Tone Mode Up
T8
or
Tone Mode Down
T7
selector buttons.
7. At the far end of the cable, spread the wires at least 2" (51 mm) apart, if possible.
8. Use the Probe-Pro to scan the cable’s wire pairs. Move the Probe-Pro's tip
P1
slowly across the wires. The
Probe-Pro’s volume will increase as it approaches the toned wire.
2"
(51 mm)
FIG. 3
FIG. 2
Press
2 mm
(3/32")
VDV500-820E-1390411ART - Pro Tone and Probe Kit - EUROPE.indd 5VDV500-820E-1390411ART - Pro Tone and Probe Kit - EUROPE.indd 5 8/2/21 10:04 AM8/2/21 10:04 AM
Loading ...
Loading ...
Loading ...