Loading ...
Loading ...
Loading ...
12
Copyright © 2022-2023 LG Electronics Ins.
All right reserved.Only training and service purposes.
Disassembly
9. Capacitor
1. Remove the control box. (Refer to section 3)
2. Remove the knobs and the screw
that fasten control panel from control box.
3. Remove the screw that located in the front.
4. Open the bottom side of control box.
5. Remove the screw and the clamp
that fastens the capacitor. (See Figure 11)
6. Disconnect all the leads of capacitor terminals.
7. Re-install the components by referring to the removal
procedure, above.
10. Power Cord
1. Remove the control box. (Refer to section 3)
2. Open the control box. (Refer to section 9)
3. Disconnect the grounding screw from the controlbox.
4. Disconnect the 2 receptacles.
5. Remove the screw which fastens the clip cord.
(See Figure 12)
6. Remove the power cord.
11. Thermistor
1. Remove the control box. (Refer to section 3)
2. Open the control box. (Refer to section 6)
3. Disconnet the thermistor terminals from main
P.W.B assembly.
4. Remove the thermistor.(See Figure 13)
5. Re-install the components by refereing to the above
removal procedure.
Figure 11
Figure 12
Figure 13
Figure 14
7. Re-install the components by referring to the removal
procedure, above.
(Use only one ground-marked hoel for ground
connection.)
8. If the supply cord of this appliance is damaged,
It must be replaced by the special cord.
(The special cord means the cord that has the same
specification marked on the supply cord attached at the unit.)
12. Synchronous Motor (Optional Function)
1. Remove the control box. (Refer to section 3)
2. Unfold the control box. (Refer to section 10)
3. Remove the crankshaft.
4. Disconnect all the leads of the synchronous motor.
5. Remove the 2 screws which fasten
the synchronous motor. (See Fig. 14)
6. Re-install the components by referring to the removal
procedure, above.
Loading ...
Loading ...
Loading ...