Loading ...
Loading ...
Loading ...
3
Ambient temperature below 50°F or above 85°F will hinder the performance of this appliance. This
unit is not designed for use in a garage or any other outside installation.
Avoid locating the refrigerator in moist areas.
Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center. This unit is not designed to be installed in a caravan or used with
an inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool
down for 2~3 hours before placing food in the refrigerator or freezer compartment.
Electrical Connection
OPERATING YOUR REFRIGERATOR
Temperature Control
Your refrigerator has one control for regulating the
temperature. The temperature control is located on the
top left hand corner of the refrigerator compartment.
The first time you turn the unit on, adjust the temperature
control knob to “MAX” and run for at least 2 hours before
putting foods inside. This will ensure the cabinet is
thoroughly chilled before your food is stored.
The range of the REFRIGERATOR temperature control is
from position "MIN" the warmest to "MAX" the coldest.
Adjust the temperature control to the setting that best
suits your needs. The setting of “MED” should be
appropriate for home or office refrigerator use.
NOTE:
If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the refrigerator will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
Do not place the foods on the air outlet, and leave spaces for airflow.
If you choose to change the thermostat setting, adjust the thermostat control by one
increment at a time. Allow several hours for temperature to stabilize between adjustments.
Adjusting the temperature control in the refrigerator compartment will affect the temperature
in both the refrigerator and the freezer compartment.
Changing the Light Bulb
Before removing the light bulb, turn off the refrigerator first
and then unplug the unit from the wall outlet. Failure to do so
could result in electrical shock or personal injury.
Use Phillips screwdriver to take out screw.
WARNING
Please make sure the power socket has been fitted by a qualified electrician and the
ground wire has been connected properly. They all meet the standards of the Australia
Electrical Standards.
Loading ...
Loading ...
Loading ...