Loading ...
Loading ...
PIN-HOLE
FREESTANDING TUB
INSTALLATION INSTRUCTIONS
NOTICE: Do not support the weight of the bath by the rim.
NOTE:
Carefully unpack and inspect the new bath for damage before installation. If there is
damage do not install the bath; contact your dealer.
Make sure the flooring offers adequate support for your bath.
2. Install the Bath
Install the Plumbing
Install the faucet valve.
Check the drain connections for leakage.
3. Make the Electrical Connections
WARNING: Risk of electric shock. Make sure the power has been disconnected
before performing the following procedures.
WARNING: Risk of electric shock. Connect the blower motor to a properly grounded,
grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or
Residual Current Device (RCD). Don not remove the grounding pin from the plug. Do not
use a grounding adapter.
NOTICE: The blower motor is equipped with a cord and plug. A qualified electrician must install
a GFCI- or RCD-protected, 110V, 60Hz, grounded outlet for the blower. No other load should be
on this circuit.
Install an electrical outlet behind the bath, at least 1-1/2” above the floor, and within
reach of the 24” (610mm) power cord.
Plug the blower into this outlet.
4. Complete the Installation
Test Run the Bath
Fill the bath to a level at least 4” (102mm) above the top of the highest pinhole.
Press Start
Operate the bath for 5 minutes and check all bath piping connections for leaks. Check
for leakage all around the bath.
Clean-up After Installation
When cleaning up after installation, do not use abrasive cleansers, as they may
scratch and dull the bath surface. Use warm water and a liquid detergent to clean the
surface of the bath.
Do not allow cleaners containing petroleum distillates to remain in contact with
any bath surface for long periods of time. Do not use metal scrapers, wire brushes,
Loading ...