Loading ...
Loading ...
Loading ...
16
Step 5: Leveling your washer loosen lock
See if the washer is level by checking the position of
the tub or using a leveling gauge.
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water
into the tub to just below the pulsator level.
3. If the washer is level, the pulsator is positioned
at the center of the washer as shown in the
Figure 15. If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary. (Refer to Figure 16.)
WARNING: There is ONLY ONE adjustable leg as
right figure on this washer.
Figure 16
Figure 15
Step 6: Powering your washer
Plug the power cord into a 3-prong, well-grounded 120 Volt 60Hz approved electrical outlet protected by a 15-amp
fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord when
plugged into a 3-prong grounded electrical outlet.
Step 7: Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Place small load of laundry into the tub.
2. Press the Power button to turn on your washer.
3. Select the Rinse + Spin cycle.
4. Press the Start/Pause button to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and
should drain well during the spin cycle.
WARNING: If water leaks while water is being supplied or drained, check the water connections. If the washer
rocks and vibrates excessively, level your washer again.
Step 8: Storing your washer
If you want to store your washer at another location, unplug it, drain any remaining water from the drain pipe and
hook the pipe onto the back of the washer. Disconnect the water inlet hoses from the faucets and move washer
to new location.
pulsator
Loading ...
Loading ...
Loading ...