Loading ...
Loading ...
Loading ...
35TROUBLESHOOTING
ENGLISH
Performance
Washer stops for a
few minutes and
then restarts.
A motor protection device has been activated to prevent overheating of the motor.
This is normal. If the motor protection device is activated, the washer will stop for a few
minutes and then start again.
Washer is not filling
properly.
Filter is clogged.
Make sure that inlet filters on the fill valves are not clogged. Refer to Cleaning the Water
Inlet Filters in MAINTENANCE.
Inlet hoses may be kinked.
Check that inlet hoses are not kinked or clogged.
Energy efficiency
This is a High-Efficiency (HE) washer. As a result, the water level settings for this washer
may be different than for a conventional washer.
Insufficient water supply
Make sure that both hot and cold water faucets are turned on all the way.
Washer door is open.
Close the door and make sure that nothing is caught under the door preventing it from
closing completely.
Water level is too low.
The water will not normally cover the clothes. The fill level is optimized for the wash
motion to achieve the best wash performance.
Water in the washer
does not drain or
drains slowly.
Drain hose is kinked, pinched, or clogged.
Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under
the washer.
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
Move the end of the drain hose so that it is lower than 96 inches (2.4 m). For best
performance, the end of the drain hose should be no higher than 66 inches (168 cm).
Bleach does not
dispense.
Bleach dispenser cover is not properly installed (on some models).
Make sure that the bleach cover is properly installed and snapped into place before the
beginning of the cycle.
Bleach dispenser is dirty or clogged.
Lift out the bleach dispenser cover and clean out the reservoir. Lint and other foreign
debris that have collected inside the dispenser may prevent proper dispensing of the
bleach.
Premature
dispensing of bleach
Bleach dispenser filled for future load.
You cannot store bleach in the dispenser for future use. The bleach will be dispensed every
load.
Overfilling the bleach dispenser
Overfilling the bleach dispenser will cause the bleach to dispense immediately, which will
damage the laundry or the washer. Always measure bleach, but never fill above the max
line on the dispenser. A half cup of bleach is sufficient for most loads. Never use more than
1 cup of bleach.
Problem Possible Cause & Solution
Wrinkling Washer is not unloaded promptly.
Always remove items from the washer as soon as the cycle is complete.
Problem Possible Cause & Solution
en-us_main.book.book Page 35 Friday, November 18, 2022 8:27 AM
Loading ...
Loading ...
Loading ...