Loading ...
Loading ...
Loading ...
MAINTENANCE
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door and
slide the latch down to lift Filter Door o. Remove
the Post-Motor Filter from the base by pulling the
tab down. Tap the filters clean over the trash. Do not
use water or soap to clean filters as this will cause
damage. To reinstall the post-motor filter, insert it
into the base and replace the filter door.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, then rinse with cold water ONLY, as soap may
damage them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
first, then the foam filter.
Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12
months or as needed.
CLEANING AND REPLACING THE BASE FILTERS
Filter
Door
MAINTENANCE
CLEANING THE SELF-EMPTY DUST BIN
To remove the Self-Empty Dust Bin, pinch the release
latches on the front of the dust bin and slide it out.
CAUTION: Turn o power before performing any maintenance.
To turn the robot power o, take it o the Self-Empty Base and press the DOCK button on the robot for
5-7 seconds.
To open the dust bin lid, pinch the side latches in the
finger slots and hold them while lifting the lid.
Remove the filter and use a damp cloth to wipe the
dust bin clean. Allow the bin to air-dry for 24 hours
before reinstalling it.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
Loading ...
Loading ...
Loading ...