Loading ...
Loading ...
Loading ...
INSTALLATION
Installation usually takes approximately 20-30 minutes with 2-3
people excluding earthworks and filling.
Assembly of the Frame Pool can be completed without tools. To
lengthen the life of your pool, it is important to sprinkle the top
rail with the Talcum Powder before assembly. Talcum Powder is
not included and easily available in the market.
Bestway will not be responsible for damage caused to the pool
due to mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct
quantities as listed in the components list. For assistance or
FAQs, please visit the support section on our website,
www.bestwaycorp.com.
2. Spread out the pool and make sure the pool is right side up;
let it sit exposed to direct sunlight for 1 hour or more so that
the pool is more flexible during set up.
3. Place the pool near an adequate drainage system to deal with
overflow water and ensure the pool’s inlet A and outlet B are
correctly positioned to allow your filter pump to connect to a
power source.
NOTE: Do not use extension power cords to power your
pump.
ATTENTION: Do not drag the pool on the ground,
this can damage the pool.
NOTE: Drawings for illustration purpose only. May not
reflect actual product. Not to scale.
NOTE: The installation drawing for the Top Rail and the
T-Connector of 16 ft. x 10 ft. x 42in. (4.88 m x 3.05 m x 1.07 m).
NOTE: The installation drawing for the Top Rail and the
T-Connector of 14 ft. x 8 ft. 2 in. x 39.5 in.
(4.27 m x 2.50 m x 1.00 m).
NOTE: The installation drawing for the Top Rail and the
T-Connector of 10 ft. x 6 ft. 7 in. x 33 in.
(3.05 m x 2.00 m x 84 cm).
7
F
F
F
F
C
C
C
C
C
C
C
C
E
E
E
E
E
E
A
D
D
A
D
D
F
F
E
A
B
A
C
C
B
C
C
C
C
F
F
E
E
E
4
J
J
5
1
D
CC
C
C
D
A
2
C
C
D
F
C
C
E
C
F
C
E
E
F
E
F
3
H
H
H
I
Loading ...
Loading ...
Loading ...