Loading ...
Loading ...
Loading ...
completely (Fig. 2).
- For suction version: identify the optimal height for the rigid or flexible ex-
haust pipe (F) and connect it to the motor connection.
Phase 3
- Raise the hood, hooking it onto the 4 M5 metric screws (V4) pre-tightened
to the lattice-work (C) (center the Ø11 holes on the slot of the inner liner and
move it laterally)(Fig. 3a).
- Completely tighten the 4 M5 screws (V4) (Fig. 3b).
- Remove the masking tape (Fig. 3c), remove the four M4 metric screws (V3)
previously tightened onto the lattice-work (Fig. 3d) and slide the flue-exten-
sion assembly downwards. (Fig. 3e).
- Connect the pipe to the connection of the ceiling discharge hole. (Fig. 3f).
- Make electrical connections only after having removed electrical power sup-
ply.
- Fasten the extension to the lattice-work (C) by means of the 4 M4 metric
screws (V3), without tightening them completely(Fig. 3g).
- Block the extension completely to the lattice-work (C) by screwing down the
4 M4 metric screws (V3).
- Block the flue with the 2 self-threading screws (V5) (Fig. 3i).
- Use the extension support elements(A) (Fig. 2) only if the upper lattice-work
is not used, or in the case of a false ceiling.
- Fit the glass panels (fig. O5).
26
Loading ...
Loading ...
Loading ...