Loading ...
Loading ...
Loading ...
10
Performance Data
PERFORMANCE CLAIMS
Substance
NSF Required Influent
Challenge Level (mg/L)
1
NSF Max. Per missible Product
Water Concentration (mg/L)
1
Benzene 0.015 ±10% 0.005
Chlorine Taste & Odor 2.0 ±10% 1.0
Cyst ≥50,000 #/mL
2
99.95%
3
Lead @ pH 6.5 0.15 ±10% 0.010
Lead @ pH 8.5 0.15 ±10% 0.010
Mercury @ pH 6.5 0.006 ±10% 0.002
Mercury @ pH 8.5 0.006 ±10% 0.002
Particulate, Class I (0.5 to <1 micron) 10,000 #/mL
2
85%
3
Microplastics (0.5 to <1 micron) 10,000 #/mL
2
85%
3
1
Milligrams per liter, which is equivalent to parts per million (PPM).
2
Particles per milliliter.
3
NSF minimum percent reduction requirement. Acceptance level for this substance is based on percent
reduction, rather than maximum effluent concentration.
General Information
This system has been tested according to NSF/ANSI 42, 53 and 401 for reduction of substances listed above. The con-
centration of the indicated substances in water entering the system was reduced to a concentration less than or equal to
the permissible limit for water leaving the system, as specified in NSF/ANSI 42, 53 and 401. The testing was performed
using spiked tap water at a flow rate of 1.8 gallons per minute (6.8 L/min.), pH of 7.5 ± 0.5, pressure of 60 psig, and
temperature of 68 ± 5°F.
This product is protected by U.S. patent no’s: 6,866,704; 6872.311; 7,276,166; 7,296,691; 7,241,388; 7,287,650;
7,566,014; 8,056,733; applicable U.S. patent applications; foreign patents and foreign patent applications.
Installation Requirements
Pressure Range .....................................30-100 psig (207-689 kPa)
Temperature Range .............................................40-100°F (5-38°C)
Service Flow Rate..............................................1.8 GPM (6.8 LPM)
Service Life..............................................2000 gallons (7570 Liters)
Maintenance
Filter cartridges should be replaced every 2000 gallons or six months, whichever comes first. Purchase replacement
cartridges from the e-commerce retailer where you bought your water filtration system or www.ecopurehome.com/brita.
Replacement filter prices will vary. Estimated cost of replacement filter cartridge BRDPFF ranges from $70 to $100.
Model BRDPFS Single Stage Drinking Water Filtration System
IMPORTANT NOTICE: Read this performance data and compare the capabilities of this unit with your actual water
treatment needs. It is recommended that, before purchasing a water treatment unit, you have your water supply tested to
determine your actual water treatment needs. This filter system is designed to be used for the reduction of the perform-
ance claims listed below. Do not use where water is microbiologically unsafe or of unknown quality, without adequate
disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that may
contain filterable cysts. While testing was performed under standard laboratory conditions, actual performance of this
system may vary based on local water conditions. Some or all of the contaminants reduced by this unit may not be in
your water supply. See elsewhere in this owner’s manual for further instructions on filter cartridge replacement, system
installation, operating procedures, and warranty. The maintenance instructions must be followed for the product to per-
form as indicated below.
System tested and certified by NSF International against NSF/ANSI
Standards 42, 53 and 401 for the reduction of claims specified on the
performance data sheet at www.nsf.org and NSF/ANSI/CAN 372.