Loading ...
Loading ...
Loading ...
13
MAINTENANCE
1
4
2
5
3
Remove
Six Screws
Replacing The Drive Belt
Make sure the vacuum is switched off and unplugged first
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt appears
worn, you will need to replace it. To remove the drive belt, read the instructions and follow the
drawings below:
1. Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
2. Loop new drive belt over motor shaft and stretch other end over floor brush in the space
provided between the bristles.
3. Place ends of floor brush down into slots on sides as shown.
4. Turn floor brush by hand several times in the direction of the motor shaft.
5. If properly installed, drive belt will align itself on floor brush.
6. Replace brush cover and six screws.
SC15830_32_34_IM.indd 13 14/01/2019 11:16
Loading ...
Loading ...
Loading ...