Loading ...
Loading ...
Loading ...
6/21 Rev. E 171375
9
LOADING PRODUCT
Once that cabinet has been operating at the desired temperature for a sufficient period of time, product can be
loaded into the cabinet.
IMPORTANT
• When loading product use caution not to block airflow to achieve maximum cooling performance.
• Do not load product where it would block the air intake or discharge at the back inside wall of the cabinet.
• Do not load warm product into the cabinet as it will affect the cabinet temperature and products previously
stored in the cabinet.
• Products should be in covered containers or wrapped to prevent cross contamination.
CAPSULE PAK LATCH AND DIFFUSER INSTALLATION INSTRUCTIONS
1. Remove diffuser from ceiling panel before installing ceiling panel (Figures 1 and 2)
2. Lift Capsule Pak into position on top of walk-in. Note: Do not slide Capsule Pak into position as cowl gasket
damage will occur. If the Capsule Pak™ must be slid into position, place Capsule Pak on a piece of cardboard
prior to moving to prevent gasket damage.
3. Inspect cowl gasket to ensure proper placement (Figure 3)
Figure 3
Figure 2
Figure 1
geneRal installatiOn instRuctiOns
Loading ...
Loading ...
Loading ...