Loading ...
Loading ...
Loading ...
4
ENG
INSTALLATION
Location
Reversing the Door Swing (optionnal)
Tools Required: Phillips style screwdriver / Flat blated screwdriver / Hexagonal spanner.
1. Remove the top hinge cover .
The top hinge cover
When selecting a position for your unit you should make
sure the floor is flat and firm, and the room is well ventilated.
Avoid locating your unit near a heat source, e.g. cooker,
boiler or radiator.
Also avoid direct sunlight as it may increase the electrical
consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly. This unit is not
designed for use in a garage or outdoor installation. Do not
drape the unit with any covering.
When installing the unit, ensure that 10 cm of free space is
left at both sides, 10 cm at the rear and 30 cm at the top of
the unit. This will allow cold air to circulate around the wine
cooler and improve the efficiency of the cooling process.
2. Remove the screws fixed the top-hinge with cross-slot
screwdriver.
3. Replace the top-hinge and the top-door limit block and the
door bearing bush to the other side.
A. Remove the nut with sleeve.Take off the washer then
remove the axes to the other side and fixed.
B. Remove the door limit block
C. Please taking out another door limit block, with screw
mounting to the door
Screw (three)
Loading ...
Loading ...
Loading ...