Loading ...
Loading ...
Loading ...
1. Stretch a piece of string along the hedge at this
height.
2. Cut the hedge immediately above this string.
3. Cut the side of a hedge until it will be narrower at the
top. More of the hedge will come into view in that
way.
7 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Pull the mains plug out of the socket before maintenance.
7.1 CLEAN THE MACHINE
WARNING
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
7.2 LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
NOTE
We recommend to use the non-pollutant type oil.
8 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
9 TROUBLESHOOTING
Problem Possible cause Solution
The motor does
not start when you
pull the trigger.
Cord not plugged
in.
Plug in cord.
Cord or switch is
damaged.
Have cord or
switch replaced.
The machine
smokes during op-
eration.
The machine has
damage.
1. Immediately
stop the ma-
chine.
2. Disconnect the
plug from
power source.
3. Speak to serv-
ice center.
The motor is on,
blades do not
move.
The machine has
damage.
Do not use the ma-
chine and speak to
service center.
The blades are
blocked.
Disconnect the
plug from power
source then clear
blockage from the
blades.
There is too much
noise and/or vibra-
tion during opera-
tion.
The parts are loos-
en.
1. Stop the ma-
chine.
2. Disconnect the
plug from
power source.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
The parts have
damage.
Do not use the ma-
chine and speak to
service center.
10 TECHNICAL DATA
Voltage 4A, 120 V
No load speed 3200 (±10%) SPM
Blade length 22''
Cutting capacity 3/4''
Weight 2.6 kg (5.7 lbs.)
8
English
EN
Loading ...
Loading ...
Loading ...