Loading ...
Loading ...
Loading ...
8
Complete Installation
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
2. Use a drill bit to drill a starter hole through the (3mm)
hole in the top rail.
3. Attach top channel to window sash with one
(19mm)
3/4"
1 /8"
screw to secure window in place.
5. Plug into a grounded 3 prong outlet.
6. Press RESET on the power supply cord. See "Electrical
Requirements".
A. Top of lower window sash
B Foam seal.
A
B
Electrical Shock Hazard
Plug into a grounded prong outlet 3 .
Do not remove ground prong .
Do not use an adapter .
Do not use an extension cord .
Failure to follow these instructions can result in death ,
fire or electrical shock, .
WARNING
AIR CONDITIONER USE
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■
If you turn off the air conditioner, wait at least minutes 3
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Remark a line on the according to less 1/8
(3mm) than the measured width in, then cut the EVA
Foam along the line.
EVA Foam
, the side
with should facing the .
Remove the backing from the EVA Foam.
Attach one EVA Foam on the Curtain housing
adhesive Curtain housing
5. Repeat for the right-hand curtain.
B
A
A. Curtain housing
B. EVA Foam
B
A
4. Check the gap around the unit and seal it with the adhesive
seal attached.
M
check
the
gap
The M.Sealing
sponge is provided only for5K/6K BTU DOE model
Operating
your
air
conditioner
properly
helps
you
to
obtain
the
■ Air
conditioner
in
the
Cool
mode
operation the better limits:
Outdoor side 64.4~109.4°F (18~43 °C),
≤80%RH;
indoor side
62.6~89.6°F (17~32°C),
≤80%RH.
■
Air
conditioner
in
the
Heat mode operation the better limits:
Outdoor side 19.4~75.2°F (-7~24 °C),
≤80%RH;
indoor side
32~80.6°F (0~27°C),
≤80%RH.
Loading ...
Loading ...
Loading ...