Loading ...
Loading ...
Loading ...
This appliance MUST be installed in accordance with the relevant wiring rules and regulations
and in particular those regulations which cover installation of appliances and accessories in
damp situations such as bathrooms, showers, laundries and other areas with fixed water
containers.
It is to be fitted in accordance with applicable Australian/New Zealand standards (AS/NZS).
The means for disconnection must be incorporated in the fixed wiring in accordance with the
wiring rules.
WARNING: In order to avoid a hazard for very young children, this appliance should be installed
so that the lowest heated rail is at least 600 mm above the floor.
Special purpose tools are required for the replacement of the power supply cord and element.
Contact an Authorised Service Agent for service.
PLEASE NOTE: CBD takes no responsibility for instances where walls/tiles have been drilled
without correct measurements being taken by the installer – ensure you have the correct
measurements before drilling any holes.
PLEASE NOTE: CDB takes no responsibility for instances that occur where heated towel rails
have not been installed according to AS/NZS standards.
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
[email protected]om.au
SUPPORT AND TECHNICAL ADVICE
Installation cont.
Care and Cleaning
The Towel Rail requires regular cleaning to ensure longevity of the product. Turn off the
isolating switch before cleaning. For additional protection, turn the mains supply off
before cleaning. Ensure that the towel rail has been allowed to cool down completely
before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the towel rail to remove dust and dirt
Ensure the Towel Rail is dry before switching back on the mains supply and isolating
switch
RUST
Surface rust can occur on stainless steel over time. To avoid this the Heated Towel Rail is
best wiped down from time to time with a damp cloth and a stainless-steel cleaner. Fine
scratching can be removed using a metal polish such as ‘Autosol’ or ‘Brasso’ Paste which
are available from most supermarkets and car care shops.
DO NOT USE ANY ABRASIVE OR CORROSIVE CLEANERS.
Loading ...
Loading ...