Loading ...
Loading ...
Loading ...
5
Blender Jar Assembly is as Follows:
1. Turn the Blending Jar upside down and place on a flat surface. Add the Blade to the Base
and top with the Rubber Gasket.
2. Place the Blade Assembly with the Gasket between the Plastic and the Blade. Turn the
Base clockwise until it is tightly secured.
3. Turn the assembled jar right side up. You may choose to add water to the jar over a sink to
make sure the base was positioned correctly and does not have leakage.
Use caution when washing the blade assembly. The blades are extremely sharp and can
cause injury if not handled with care.
Before First Use
IMPORTANT: Please check all packaging material carefully before discarding as there may be
accessory parts contained within the packaging material.
NOTE: When using your blender, please allow the blender to cool between multiple uses.
Do not run your blender for more than 3-4 minutes continuously. Allow the motor to cool 1-
2 minutes, in between cycles, before proceeding.
WARNING: The blades are very sharp. Use extreme care when handling. Before your first
use, wash the Plastic Jar, Filler Cap, Lid, and Blade Assembly using warm soapy water. Rinse
well and dry before reassembling.
Using Your Blender:
WARNING: Avoid contact with moving parts.
1. Place the Motor Base on a clean, flat surface. Fill your Plastic Jar with your favorite
ingredients; do not fill past the Max line.
CAUTION: Add liquids first and do not overfill the product or operate it when empty.
2. Insert the Plastic Jar to the Motor Base turn until the slots are in place and lock. Add the lid
with the Filler Cap in place.
Note: The Filler Cap allows you to add ingredients while blending.
3. Connect Plug to the nearest 120 V AC electrical outlet. Pulse your beverage to the
consistency and speed of your preference.
Note: Push the Hi/Low Button for Speeds 1-6, and leave the button out for High Speeds 7-12
Attention: First use may cause a slight odor or small smoking upon heating, it is normal. This is
a result of the heating element chemical reaction. It quickly goes away.
4. When you have finished blending, press the pulse/off button. Make sure the blades have
come to a complete stop before attempting to remove the jar from the base. Turn the Jar
counterclockwise to remove from the base.
5. Lift Jar from base remove the lid and serve.
Blending Tips:
• When blending thick mixtures such as smoothies, power drinks or milkshakes; press the
pulse button several times to begin the blending process.
• Filler cap should only be removed to add ingredients. Do not remove the lid while the
blender is in use.
Loading ...
Loading ...
Loading ...