Loading ...
Loading ...
Loading ...
Installing the Light Kit
8.
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
If you do not plan to install the light kit
with your fan at this time, skip step 2.
1. Remove 1 of 3 screws from the mounting plate
and loosen the other 2 screws. (Do not remove)
2. While holding the LED light kit under the fan
motor assembly, make the 2-pin wire connections:
- White to white
- Black to blue
3. Place the key holes in the LED light kit over
the two mounting screws previously loosened
from the mounting plate. Turn the LED light kit
until the LED light kit locks in place at the
narrow section of the key holes. Secure by
tightening the two screws previously loosened
and the one previously removed. (Fig. 14)
4. Raise the glass shade (or metal light cover) up
against the LED light kit and secure it to the fan
by turning the glass shade clockwise until snug.
DO NOT OVERTIGHTEN. (Fig. 14)
NOTE: The metal light cover included with your
fan is an option to replace the glass for the light in
the event that you prefer not to use the light
feature of your fan. The metal light cover is not
necessary for the light operation; it can be saved
for later use if desired.
Figure 14
Screws
Glass
shade
Mounting
plate
Wire connector
LED
Light kit
Loading ...
Loading ...
Loading ...