IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be taken, including
the following. Read all instructions before using this appliance.
DANGER – To reduce the risk of electric shock:
1) Always unplug this appliance from the electrical outlet immediately after using or before
cleaning.
2) Do not place or store power pack where it can fall or be pulled into a tub or sink. Do not fully
immerse in or drop into water or other liquids. Store in a dry place, out of reach of children.
3) Do not reach for an appliance that has fallen into water. Unplug immediately.
WARNING – To reduce the risk of burns, fire, electric shock, or injury
to persons:
1) An appliance should never be left unattended when plugged in. Unplug from outlet
when not in use and before putting on or taking off parts.
2) This appliance is not a toy!
3) Consult your doctor before using in case of pregnancy, illness, medical condition, or
persistent pain.
4) Do not use on any unexplained pain or swollen muscles, or following a serious injury,
before consulting your physician.
5) Do not use appliance in close proximity to loose clothing or jewelry.
6) Keep long hair away from appliance while in use.
7) This appliance should not be used by, on, or near children or individuals with certain
disabilities.
8) Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by Conair.
9) Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, or if the power pack has been dropped or submersed in water. Return the
appliance to a service center for examination and repair.
10) Do not carry this appliance by the power-supply cord or use the cord as a handle.
11) Keep the cord away from heated surfaces.
12) Never drop or insert any object into the product.
13) Do not use outdoors.
14) Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
15) For use with the Conair-supplied adapter CA79 only.
16) Use the class 2 power supply in a dry location only.
17) This power unit is intended to be correctly oriented in a vertical or floor-mounted position.
18) Do not handle plug with wet hands. Ensure that your hands are dry when operating the
controls or removing the plug.
19) To disconnect, turn to the OFF position, then remove plug from outlet.
20) This appliance is for household use only.
21) Never use while sleeping or drowsy.
22) Keep out of the reach of children.
IMPORTANT
Keep hair, fingers, skin, and loose clothing or articles away from suction openings located on
sides of unit while Hydro Spa is in operation. Otherwise, personal injury may result. Use of a
shower cap is recommended for persons with long hair. Do not use the Hydro Spa with bath
oil in the tub water, as this may affect performance of unit.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
CAUTION
• This unit should not be used in the following cases unless directed by physician:
tuberculosis, benign and malignant tumors, hemorrhages, inflammations of the skin,
phlebitis and thrombosis, open and fresh wounds, bruises, broken skin or varicose veins,
or undetermined calf pain.
• Consult your physician if you have any questions regarding therapeutic use of this Hydro
Spa.
• Do not use if you have any unexplained pain before consulting your physician.
• Discontinue use of unit if pain is present or increases or if swelling occurs after use.
• Do not use on any part of the body that is anesthetized.
• Do not use if you’ve had recent surgery.
• Never use without removable filters.
• If you are pregnant, consult your physician before use.
• Never run your Hydro Spa without water.
• Read safety and operating instructions carefully. This product is intended for indoor use on
permanent right-wall tubs. Do not use outdoors or on the walls of inflatable tubs or pools.
HOW TO USE
1) With unit securely placed on tub (see “How to Attach Your Hydro Spa to Your Tub”), place
the power pack as far away from tub as possible so that it cannot easily be pulled into tub.
2) Hydro Spa is connected to the power pack by a 15 ft. line cord. Insert plug into power
pack with indexing tab facing down.
3) Plug power pack into 120V wall outlet. Make sure power pack is not on the floor of the
bathroom to minimize water exposure to the power pack.
4) Fill bathtub with warm water. Ensure water temperature is comfortable to avoid burns. Never
use boiling water with your Hydro Spa.
5) Adjust height of motor assembly so that water jets are beneath water. This can be done
by moving the motor assembly up and down vertically; the housing employs detents that
hold the motor assembly at the desired height. KEEP THE WATER LEVEL IN THE TUB
ABOVE THE FILL LINE ON BODY OF DEVICE.
6) Point the water jets downward.
7) Adjust the control switch on the side of the unit to either “Jet Stream” or “Bubbles”
(see Fig. 1).
8) Turn the knob on the top of the Hydro Spa to ON (see Fig. 2).
9) Adjust the water jets to create customized water flow in your bathtub.
10) After use, turn the knob to the OFF position (see Fig. 2), drain water from tub, then
remove Hydro Spa.
11) Tilt your Hydro Spa gently over the bathtub to remove excess water, and dry with a soft
cloth before storage.
CAUTION: IF Hydro Spa FALLS AND BECOMES
COMPLETELY IMMERSED IN WATER IN TUB, DO NOT
PANIC. UNPLUG FROM WALL OUTLET FIRST. THE Hydro
Spa HAS BEEN DESIGNED TO WITHSTAND SUBMERSION.
UNPLUG FROM WALL OUTLET FIRST, THEN REMOVE UNIT
FROM BATHTUB. TURN UNIT OFF, DRAIN WATER FROM
TUB, AND STORE UNIT IN A DRY PLACE.
NOTE
You may experience some water spray if the unit shifts during operation. Do not overfill your
tub. For best results, get into your tub before filling.
(Note: Too much water can cause overflow.)
The Conair
®
Jet Hydro Spa can help you relax, relieve tension, and soothe sore muscles.
Consult your physician or physical therapist for recommendations regarding Hydro Spa use,
including water temperature, duration, and frequency.
CARE AND MAINTENANCE
1) Keep your unit clean and clear of obstruction. Check the water jets
and inlet filters periodically to make sure they are free of obstruction,
hair, lint, and other particles that could block air or water flow. Clean
inlet filters by removing filter caps and rinsing cap under running
water. Reinsert on Hydro Spa by using the provided alignment
marks. See “Fitting and Removing Filter Caps.”
2) Store your Hydro Spa in a cool, dry place. Loosely coil the power
cord and lay flat to store. Do not wrap cord around Hydro Spa or
power pack.
FEATURES
1) Dual multidirectional water jets
2) Telescopic housing
3) Jet stream or bubbles switch
4) Removable filters
5) Compact convenience
Foldable arm
for easy storage
OFF/ON
Adjustable
suction cup
for edge of tub
3) Bubbles/Jet Stream
control switch on side
2) Adjustable
motor height
Suction cups
for bathtub wall
Filter
alignment tabs
4) Removable
filter on each side
1) Dual
multidirectional
water jets
Jet Stream Bubbles
Fig. 1
Fig. 2
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
All HYD100 Models
™
Loading ...
Loading ...
Loading ...
