Loading ...
Loading ...
Loading ...
Operating the Single Surface Radiant
Elements
The cooktop has 2 or 3 SINGLE radiant surface elements:
the LEFT FRONT position and the CENTER REAR position,
and the CENTER RIGHT position (on the 30" model only).
The left front element may also be used with the Bridge
element (Figures 1 and 2).
To Operate the Single Radiant Surface
Elements
1. Place correctly sized cookware on the radiant surface
element.
2. Push in and turn the surface control knob in either
direction to the desired setting (Figure 3).
3. Turn the knob to adjust the setting if desired. Start
most cooking operations on a higher setting and then
turn to a lower setting to finish cooking. Each surface
element provides a constant amount of heat at each
setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates
the cookware is too small for the surface heating
area.
4. When cooking has completed, turn the surface
control knob to OFF before removing the
cookware.
The surface "Element On" indicator lights will glow
when one or more elements are turned on. A quick
glance at these indicator lights when cooking is finished
i is an easy check to be sure all surface elements are
......turned off, ......................................................................................................................................................................................................................................................................................................................................
See Recommended Setting for Single Elements table on
Do not place plastic items such as salt and pepper
shakers, spoon holders or plastic wrappings on
cooktop when it is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch
Do not allow aluminum foil, or ANY material that
can melt to make contact with the ceramic glass
cooktop, If these items melt on the cooktop they will
damage the ceramic cooktop.
Figure 1
Figure 2
Figure 3
The "Hot Surface" indicator lights will glow when the
element is turned on and will continue to glow after the
control knob is turned to the "OFF" position. It will glow
until the heating surface area has cooled sufficiently.
The glass surface may still be hot and burns may
occur if the glass surface is touched before the indicator
light has turned OFR The message may remain on even
though the controls are turned OFR
Loading ...
Loading ...
Loading ...