Loading ...
Loading ...
Loading ...
REMOVABLE KNOBS
The control knobs may be removed for easy cleaning by
pulling the knob straight off stem. Be sure that the knob
Is In the OFF posltlon before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up.
Caution: Read these instructions carefully be-
fore replacing the knobs. Replacing the knobs
improperly will damage the knobs and the spring
clip on the stems. If this happens, the knobs will
fit loosely.
To replace the knob:
1. The knob stem hasa groove In each side. The groove
on one side has a spring clip. The other groove Is
clear (see illustration).
MOLDED
RIB
SPRING
CLIP
2. Check the Inside of the knob and find the molded rib.
3. Replace the knob by fitting the molded rib Inside the
knob Into the clear groove on the stem.
REMOVABLE COOKTOP UNITS
The cooktop elements can be unplugged and the bowls
removed for cleaning.
Be sure all cooktop unit control knobs are turned
off and elements are cool before you remove or
replace a cooktop unit.
To remove:
1. Grasp element, tilt It upward slightly to clear the
bowl, then pull away from the receptacle. The element
will not sit level when replaced if It Is forced too far
upward when removed.
2. For models with porcelain enameled reflector bowls,
remove the chrome trim ring. See the Cleaning
Section about Information on cleaning porcelain
enameled reflector bowls.
3. Lift out the bowl.
Do not put the element Into water. It cleans Itself when
heated during normal use.
IMPORTANT: Never operate a cooktop element
without the bowl in place. This can cause
scorching of the cooktop, burning of wiring insu-
lation end loss of energy,
To replace:
1. Replace the bowl. Be sure the receptacle Is shewing
In the bowl opening.
2. For models with porcelain enameled reflector bowls,
replace chrome trim ring.
3. Slide the plug ofthe element firmly Into the receptacle
and lower the element Into place.
REPLACING THE OVEN LIGHT
Be sure that the light switch is in the off position.
Do not touch hot oven bulb. Do not touch oven
bulb with wet hands. Do not wipe oven light area
with wet cloth.
Never touch the electrically live collar on the
bulb when replacing it.
Electrical power must be shut off if you have to
replace a broken bulb.
1. Unscrew glass cover and remove.
2. Replace the bulb with a 40 watt appliance bulb.
3. Replace the cover.
Note: We recommend you use a 40 watt appliance bulb
that Is no longer than 3 1/2".
17 NEMNT49
Loading ...
Loading ...
Loading ...