Loading ...
Loading ...
3
Operation
1. Remove the Filter Basket, and place a Filter Paper into the Filter Basket. Put appropriate amount of
coffee in the Filter Paper (your coffee supplier should be able to provide you with information about
correct yields).
2. Slide the Filter Basket into position.
3. Place the empty decanter (Pot or Airpot) at the correct position under Filter Basket.
4. Turn the power switch ON. Press the Brew button; the “Filling” & “Heating” indicator will light.
5. Coffee will start to flow into the pot in approximately 90 seconds.
6. When the "Heating" indicator light turns off, the brewing cycle has completed. Do not remove vessel
or Filter Basket away until coffee stops flowing.
7. Brew cycle is completed.
8. Dispose of used grounds coffee and filter paper; rinse Filter Basket in clean water.
*Note -
- The tank must be full of water before connecting the brewer to electrical power.
- Water will always remain in the hoses and boiler of the unit. If the brewer should be
moved or removed for service, be sure to pour out the remaining water. Failure to comply can cause
serious burns.
- To avoid splashing or overflowing hot liquids, always place an empty airpot or server under the
filter pan before starting the brew cycle. Failure to comply can cause serious burns
CLEANING – NOTE: To maintain cleanliness and increase service life, the brewer should be cleaned daily. Do
not immerse the unit in water or any other liquid. If liquid enters the electrical compartment it may cause a
short circuit or electrical shock.
1. Allow unit to completely cool before cleaning.
2. Disconnect the cord from the outlet.
3. The Coffee Maker must not be cleaned by a water jet.
4. Wipe the outside of the unit with a damp cloth, then wipe dry.
5. To avoid damage, do not use abrasive cleaners or scouring pads.
6. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water
immediately after cleaning. Chemical residue could damage or corrode the surfaces of the unit.
Loading ...
Loading ...
Loading ...