Loading ...
Loading ...
Loading ...
The L-side of the selector button is pushed to
turn the bit counterclockwise (See Fig. 13).
(The
and marks are provided on the body.)
marks marks
Trigger switch
Selector button
Fig. 13
CAUTION
The push button can not be switched while the
power tool is turning. To switch the push button,
stop the power tool, then set the push button.
5. Change rotation speed.
Shift knob
Low speed
Fig. 14
Shift knob
High speed
Fig. 15
Operate the shift knob to change the rotational speed.
Move the shift knob in the direction of the arrow (See
Figs. 14 and 15).
When the shift knob is set to “LOW”, the drill rotates at
a low speed. When set to “HIGH”, the drill rotates at a
high speed.
CAUTION
●
When changing the rotational speed with the
shift knob, confi rm that the switch is off .
Changing the speed while the motor is rotating
will damage the gears.
●
When a large force is required for operation
(operations indicated in the following chart) set
the shift knob to “LOW”. If “HIGH” is set and the
unit is used, it may cause the motor to burn out
or malfunction prematurely.
6. The scope and suggestions for uses
The usable scope for various types of work based
on the mechanical structure of this unit is shown in
Table 8.
Table 8
Work Cap position Suggestions
Drilling
Brick
(DV18DBL2)
Use for drilling purpose.
Wood
Use for drilling purpose.Steel
Aluminum
Screw tightening
Small screw 1 – 22 Use the bit and socket matching the screw diameter.
Wood screw
1 –
Use after drilling a pilot hole.
7. Confi rm the clutch dial position (See Fig. 16).
<DS18DBL2>
The tightening torque of this unit can be adjusted
according to the clutch dial position, at which the
clutch dial is set.
15
English
000BookDS18DBL2metabo.indb15000BookDS18DBL2metabo.indb152018/09/2715:57:202018/09/2715:57:20
Loading ...
Loading ...
Loading ...