Loading ...
WARNING IMPORTANT SAFETY INSTRUCTIONS – Read before using!
Will shred: Paper, plastic credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
file folders, X-rays or plastic other than noted above
Paper shred size: Cross-Cut, LX170 - 5/32 in x 1-1/16 in (4mm
x 27mm), LX180/LX190 - 5/32 in x 1-3/8 in (4mm x 35mm)
Maximum Sheets per pass:
LX170 - 12*, LX180 - 16*, LX190 - 20*
Maximum Paper entry width: 9 in. (230mm)
Plug in and put disconnect power
switch in ON (I) position
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.75Amps (LX170), 4.58Amps (LX180), 6.25Amps (LX190); heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: *1000 sheets per day, 25 credit cards. Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees
Celsius) and 40 – 80% relative humidity.
CAPABILITIES
BASIC SHREDDING OPERATION
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
2
1
6
PAPER OR CARD
A. SafeSense
®
Technology
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
LX170
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX180
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX190
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
1
ENGLISH
ƽ 4TIVEXMSRQEMRXIRERGIERHWIVZMGIVIUYMVIQIRXW
are covered in the instruction manual. Read
the entire instruction manual before operating
shredders.
ƽ 0IITE[E]JVSQGLMPHVIRERHTIXW0IITLERHW
away from paper entry.
ƽ 0IITJSVIMKRSFNIGXWƳKPSZIWNI[IPV]GPSXLMRKLEMV
IXGƳE[E]JVSQWLVIHHIVSTIRMRKW.JSFNIGXIRXIVW
top opening, switch to Reverse (
) to back out
SFNIGX
ƽ )4348YWIEIVSWSPTVSHYGXWTIXVSPIYQFEWIHSV
aerosol lubricants on or near shredder. DO NOT USE
“CANNED AIR” OR “AIR DUSTERS” ON SHREDDER.
Vapors from propellants and petroleum based
PYFVMGERXWQE]GSQFYWXGEYWMRKWIVMSYWMRNYV]
ƽ LEVTIHKIW)4348XSYGLI\TSWIHGYXXMRKFPEHIW
under shredder head.
ƽ )SRSXYWIMJHEQEKIHSVHIJIGXMZI)SRSX
disassemble shredder. Do not place near or over
heat source or water.
ƽ 8LMWWLVIHHIVLEWE)MWGSRRIGX5S[IV[MXGL
(F) that must be in the ON (
) position to
operate shredder. In case of emergency, move
switch to OFF (O) position. This action will
stop shredder immediately. Always turn off or
unplug when not in use for an extended period
of time.
ƽ LVIHHIVQYWXFITPYKKIHMRXSETVSTIVP]
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed
RIEVXLIIUYMTQIRXERHIEWMP]EGGIWWMFPI
Energy converters, transformers, or extension
cords should not be used with this product.
ƽ +.7*-&>&7)Ƴ)S348WLVIHKVIIXMRKGEVHW
with sound chips or batteries.
ƽ +SVMRHSSVYWISRP]
ƽ 9RTPYKWLVIHHIVFIJSVIGPIERMRKSVWIVZMGMRK
2
LXȦȮȉ/LXȦȁȉ
LXȦȟȉ
F.
G.
A.
B.
D.
E.
C.
F.
A.
B.
D.
E.
C.
G.
Loading ...
Loading ...
Loading ...