Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
28
Information on the display panel
Faults and what to do about them.
Display Cause/Remedy
- P - and ¼ The door is unlocked. It is possible to add laundry.
- P - The temperature is too high. Wait until the temperature drops.
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the A button to continue the programme.
¼ flashes Laundry may be caught. Open and close the door again and press the A
button.
If necessary, push the door closed or remove some laundry and then push it
closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
r lights up Turn on the tap fully,
Supply hose kinked/trapped,
The water pressure is too low. Clean the filter. ~ Page 26
E:18 The drain pump is blocked. Clean the drain pump. ~ Page 25
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 26
E:23 There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services. ~ Page 30
E The childproof lock is activated – deactivate it. ~ Page 22
Å lights up Too must foam has been detected and an additional rinse cycle has been activated.
Add less detergent to the next washing cycle with the same load.
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call customer services. ~ Page 30
Faults Cause/Remedy
Water is leaking from the
machine.
Attach the drain hose correctly or replace it.
Tighten the screw fitting on the supply hose.
The machine is not filling
with water.
Detergent is not being
dispensed.
Have you pressed the A button?
Is the tap turned on?
Could the filter be clogged? Clean the filter. ~ Page 26
Is the supply hose kinked or trapped?
The door cannot be
opened.
The safety function is activated. Stop the programme? ~ Page 23
Is $ selected (Rinse Stop = no final spin)? ~ Page 23
Can the door only be opened by the emergency release? ~ Page 27
The programme will not
start.
Have you pressed the A button or selected Finish in time?
Is the door closed?
Is the E childproof lock activated? Deactivate it. ~ Page 22
Loading ...
Loading ...
Loading ...