Loading ...
Hook: To hang the detector when detecting
Pressure gauge: To indicate the working pressure
Working indicator: It is lit when the detector works
Oil Filler: To fill oil
Power switch: Power it on, and the detector works
Smoke output tube: The smoke outlet which connecting with detection port
Cooling hole: The heat from the work will be scattered
4.Operation
1. Open the engine cover, and hang the detector in the cover.
2. Disconnect the pipe that needs to be connected with detector. If the pipe needs to be
disconnected in the middle, please secure the other side with a rubber stopple.
3. Secure this side with proper taper stopple/pipe, and connect it with smoke output tube.
4. Connect detector with DC12V battery: red with positive, black with negative. Do not connect in
a contrary way.
5. Turn on the power switch, and the detector starts to work.
6. In about 3 minutes, the pipe will be filled with smoke. Check the leak points. Please use head
lamp if necessary.
7. After leak detection, please connect well the wires and pipe.
Notes:
* Please do leak detection away from smoke-sensitive parts.
* Do not run the detector over 8 minutes. It needs interval rest.
* The detector has protector. If it exceeds working limit, it will power off automatically. In this
condition, please operate it later.
* The round part of this detector is with temperature, be careful to avoid scalding injury.
5.Maintenance
With longtime high temperature, the smoke and oil will oxidize and deteriorate. It will infect the
service life of smoke generated part, so please change smoke and oil regularly.
1. Before filling fresh oil, please pour out the remaining oil in the detector.
2. When the smoke output has water drops, please replace with fresh oil.
3. Liquid paraffin and baby oil are OK.
Please fill fresh oil with equipped oil bottle
Loading ...