Loading ...
Loading ...
Loading ...
en Programme default settings
18
Starching
Note:
Laundry must not be treated with
fabric softener.
Starching is possible in all wash
programmes if liquid starch is used.
Measure starch into compartment M in
accordance with the manufacturer's
instructions (clean first if necessary).
Dyeing/bleaching
Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to
bleach clothes.
Soaking
1.
Switch on the appliance.
2. Select the Cottons 30 °C
programme.
3. Pour soaking agent/detergent into
compartment II in accordance with
the manufacturer’s instructions.
4. Press the A button. The
programme starts.
5. After approx. 10 minutes, press the
A button to pause the programme.
6. Leave the laundry to soak for as long
as required, then either press the A
button again to continue the
programme or change the
programme.
Notes
■
Load laundry of the same colour.
■ No additional detergent is required;
the soaking solution is used for
washing.
0 Programme default
settings
Programme default settings
The default programme settings are
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~ Page 14.
Temperature
°C s
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
(Spin 0)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting $: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop” to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~ Page 23
The maximum speed that can be set
depends on the model and programme
that has been selected.
Loading ...
Loading ...
Loading ...