Loading ...
Loading ...
Loading ...
Energy saving tips
WARNING
Connecting your refrigerator to systems that save energy is
dangerous as they may cause damage on the product.
• Do not leave the doors of your refrigerator open for a long time.
• Do not put hot food or drinks in your refrigerator.
• Do not overload the refrigerator. Cooling capacity will fall when the air circulation in the
refrigerator is hindered.
• Do not place the refrigerator in places subject to direct sunlight. Install the product at least
11 13/16" away from heat sources such as hobs, ovens, heater units and stoves and at
least 2" away from electrical ovens.
• Pay attention to store your food in refrigerator in closed containers.
• You can remove the drawer shelf of the freezer compartment to fill the freezer
compartment with maximum amount of food. The given energy consumption value of
the refrigerator has been determined with the freezer compartment shelf or the drawer
removed and the refrigerator filled with maximum amount of food. There is no harm in
using a shelf or drawer according to the shapes and sizes of food to be frozen.
• Thawing the frozen foods in the fridge compartment both saves energy and reserves the
quality of the foods
ATTENTION
Temperature of the room where your refrigerator is located should
at least be 16°C/61°F. Operating your refrigerator under cooler
conditions is not recommended with regard to its efficiency.
ATTENTION
Inside of your refrigerator must be cleaned thoroughly.
ATTENTION
If two coolers are to be installed side by side, there should be at least
1 1/2" distance between them.
Recommendations About the Fresh Food Compartment
• Make sure that the food does not touch the temperature sensor in fresh food
compartment. To allow the fresh food compartment to keep its ideal storage temperature,
the sensor must not be hindered by food.
• Do not place hot foods or beverages inside the product.
Initial use
• Before using the product, make sure that all preparations have been made in accordance
with the instructions given in the "Important instructions regarding safety and environment"
and "Installation Instruction" chapters.
• Clean the interior of the refrigerator as recommended in the “Maintenance and cleaning”
section. Before you start the refrigerator, make sure that the interior is dry.
• Plug the refrigerator in a grounded socket. The interior illumination is lit when the door of
the refrigerator is opened.
• Operate the refrigerator for 6 hours without placing any food in it and do not open its
door unless it is necessary.
ATTENTION
You will hear a noise when the compressor starts up. The liquids and
gases sealed within the refrigeration system may also give rise to
noise, even if the compressor is not running and this is quite normal.
ATTENTION
Front edges of the refrigerator may feel warm. This is normal. These
areas are designed to be warm to avoid condensation.
• Take the necessary measures against the freezing risk of the hoses.
• The water temperature operating range must be 0.6°C (33°F) minimum and 38°C
(100°F) maximum.
WARNING
Never connect the product to a cold water mains with a pressure of
5.5 bars (80 psi) and above.
7
Energy Saving Tips
8
Initial Use
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS
Loading ...
Loading ...
Loading ...