Pyle PDWMU103 User Manual

Loading ...

www.PyleUSA.com

BODYPACK TRANSMITTER

1. Antenna

2. Volume Adjust and ON/OFF button

3. Microphone Connector

4. CH Button DOWN

5. CH Button UP

6. LED Display

7. Battery compartment

Double AA batteries (AA 1.5VX2)

8. Headset microphone

(Lavalier microphone)

OPERATION

Tips:

Under normal circumstances, the product has been completed at the factory, and

can be used normally after opening the box, no need to adjust the frequency.

If you need to adjust the frequency, please follow the steps below.

Note: Before operating, make sure the transmitter and receiver are both o.

The operation sequence of handheld microphone:

1. Operate the transmitter

2. Open the receivers

3. Conrm at the transmitter

1. Press and hold the power button and CH button of the transmitter at the same

time until the LED display ashes then release the button.

2. Turn ON the receiver power button, please pay attention to the RF signal indicator

of receiver. Under normal circumstances, the receiver RF signal indicator ashes

continuously for 4 times and then goes out. (In this case, the receiver and the

transmitter are connected successfully.)

3. Short press the transmitter CH button to conrm the connection between the

transmitter and the receiver. At this time, the transmitter display stops ashing,

and the receiver RF signal indicator is always ON, indicating that the receiver and

the transmitter are connected successfully.

Note:

If it can’t be connected, please repeat the above operation.

(The transmitter must be operated before the receiver is turned ON.)

When the same frequency interference occurs, please short press the transmitter

CH button. At this time, the transmitter will change the frequency to avoid

frequency interference.

Bodypack Transmitter Operation Sequence

1. The transmitter and receiver are both o.

2. Press and hold " " CH button and turn ON the power switch button to "ON" at

the same time until the LED display ashes for 4 seconds, then release the " "

CH button.

3. Turn ON the receiver power button, pay attention to the RF signal indicator of

receiver. Under normal circumstances, the receiver RF signal indicator ashes

continuously for 4 times and then goes out.

(ln this case, the receiver and the transmitter are connected successfully)

4. Short press the transmitter " " CH button to conrm the connection between

the transmitter and the receiver. At this time, the transmitter display stops

ashing, and the receiver RF signal indicator is always ON, indicating that the

receiver and the transmitter are connected successfully.

Loading ...

Pyle PDWMU103 UHF Wireless Microphone System

User Manual - Page 4