Loading ...
Loading ...
Loading ...
- 10 -
6.Cleaning connection
Connected to the cleaning connection. This allows you to drain the dirty
water directly into the sewerage system or onto a flower bed.
Starting on the pressure filter
Before each start-up, you should check that the connected hoses and the
clamp are sitting correctly. The function switch must be set to the "filter"
symbol. It is imperative that you read and follow the safety instructions
before start-up.
1) Switch on the pump. Caution! The UV lamp must not be operated
without water flowing through it.
2) Check all the sealing connections. If there is leaking, it should be
adjusted.
3) Pass the filter on the power supply.
4) The filter system with integrated UV must be running permanently,
24 hours a day.
5) The UV lamp must be replaced after 8,000 hours of operation in order
to ensure that the filter UV continues to operate with optimum
effectiveness.
6) The filter system must be cleaned regularly.
Attention: in the case of a new installation, the pressure filter only
reaches its full biological cleaning effectiveness after a few weeks.
Extensive bacterial activity only starts at a temperature of +50°F or
above.
Washing the filter sponges
Suspended matter and dirt are deposited in the filter sponges over time.
These deposits reduce the effectiveness of the filter, so the filter sponges
should be cleaned regularly, e.g., every week.
The filter sponges should be cleaned when cloudy or even dirty water
flows out of the water outlet and back into the pond. (When the red
indicator in the function switch is floated on).
1) Turn clockwise until it clicks into the "clean" position.
2) Turn the cleaning handle, and the clean gear will be squeezed into the
Loading ...
Loading ...
Loading ...