Loading ...
Loading ...
Loading ...
9
RECEIVING THE JOINTER
Carefully unpack the jointer and all loose
items from the wood crate and inspect for
damage. Any damage should be reported to
your distributor and shipping agent
immediately. Before proceeding further, read
your manual thoroughly to familiarize
yourself with proper assembly, set-up,
maintenance, safety and operating
procedures.
Exposed metal parts such as the table and
fence have been given a protective coating at
the factory. This should be removed with a
soft cloth moistened with a solvent (such as
kerosene). Do not use acetone, gasoline or
lacquer thinner for this purpose. Do not use
an abrasive pad. After cleaning, it is
recommended that you cover all unpainted
surfaces with a good quality paste wax.
Crate contents:
1 jointer
1 dust chute
1 fence assembly
4 hex wrenches (3, 5, 8 and 10mm)
3 open-end wrenches (10-12mm, 12-14mm,
17-19mm)
2 push pads
1 helical cutter head tool package:
2 rabbet knives
8 two-sided standard knives
7 gibs
7 gib nuts
7 gib screws
1 hex wrench 5mm (L type)
3 hex wrenches 5mm (T type)
1 manual
1 warranty card
INSTALLATION AND
ASSEMBLY
Tools required
10mm hex wrench (provided)
Phillips screwdriver
The supplied tools are shipped inside the
bottom of the stand, and can be removed
through the dust outlet (A-Figure 5) on the left
side of the machine.
Loading ...
Loading ...
Loading ...