Loading ...
Loading ...
Loading ...
8
LOCATING THE POWER UNIT
• Locate the power unit away from the general living area in
an accessible location for cleaning and maintenance.
• Locate the power unit within 6 feet of a grounded electrical
outlet. The power unit requires a 120 VAC power source,
dedicated 15-amp branch circuit.
• Do not locate the power unit close to a source of extreme
heat (i.e.: water heater) or in an area with a high ambient
temperature (i.e.: attic, furnace room).
• If the power unit is located in a closet or a small utility
room, make sure the area is well-ventilated (e.g.: with door
louvers).
CHANGING INTAKE LINE
DIRECTION
The intake line connects to the right side of the unit. However,
it is possible to change this configuration; to connect the intake
line to the left side of the unit, follow these steps:
Remove debris pail from power unit by releasing both latches
on sides of the unit, pulling them out and then pushing up.
Detach the pail from unit.
BQ550 and
BQ500KIT: Grasp
the edges of the bag
collar and pull down;
the bag will slide off
easily. Do not pull on
the bag. Set the bag
aside.
BQ550 and
BQ500KIT: Using a
Phillips screwdriver
no. 2, remove the
screw tightening the
bag adapter and
intake elbow junction.
Disassemble the
bag adapter from the
intake elbow and set aside with its screw and nut.
All units: Disassemble
the intake elbow from
the back of the unit
using a 3/8” socket to
remove both retaining
nuts and screws.
All units: Flip the
intake elbow 180°,
then reassemble it to
the unit, taking care to
keep its gasket at its
original position.
NOTE: Ensure the
gasket is not folded in
order to prevent lack of suction and noise.
BQ550 and BQ500KIT:
Reassemble the bag
adapter to the intake
elbow. Align triangle
with small inclined
stud, then tighten
the junction using
the screw and nut
previously removed
in .
BQ550 and BQ500KIT:
Put the bag back in
place by grasping the
edges of its collar
and insert over bag
adapter. Be careful
not to tear the bag.
Ensure the collar is
positioned between
the taper ring and the
bag stopper on the bag adapter.
All units: Put the pail back in its place.
POWER UNIT INSTALLATION
WARNING
!
Do not install outdoors. Before hanging the unit,
rest it on a leveled surface to prevent it from falling
down. When performing installation, servicing or
cleaning the unit, it is recommended to wear safety
glasses and gloves.
AD0076
AO0078
BQ550 AND BQ500KIT
AD0075
BQ550 AND BQ500KIT
AD0077
AD0078
BQ550 AND
BQ500KIT
AO0080
BQ550 AND
BQ500KIT
TAPER RING
BAG STOPPER
Loading ...
Loading ...
Loading ...