Loading ...
Loading ...
Loading ...
8
Reverse
Switch
7. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires and safety cable
through the hanger ball. Position the pin through
the two holes in the downrod and align the hanger
ball so the pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 7)
8. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 8)
How to Assemble Your Ceiling Fan (Continued)
6 to 9 in.
Figure 7
Figure 8
Figure 9
9. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 9)
Hanger Bracket
Figure 6
6. Align the hole of the motor coupling cover to the
reverse switch of motor housing assembly. Securely
tighten the motor coupling cover screw using an allen
wrench 3/32”. (Figure 6)
Motor Coupling
Cover
Allen Wrench
3/32”
Allen Wrench 3/32” X 1
HARDWARE USED:
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Loading ...
Loading ...
Loading ...