Loading ...
Loading ...
Loading ...
3029
MAINTENANCE AND CLEANING
REPLACING THE OVEN BULBS
To replace the oven light bulb, unscrew the protection cap that projects out inside the
oven.
NOTE: Touching the bulb with your fingers may cause the bulb to burn out. Always
use protective gloves or a clean cloth to remove the bulb.
CLEANING YOUR RANGE
• Cleaning after Installation: Use a stainless steel cleaning product or wipe to
eliminate the glue residues of the protection film after removal.
• Cleaning the Worktop: Periodically clean the burner heads, the cast iron pan
supports, and the burner caps using warm water. Remove burner food and fat
residues with a rubber spatula.
• Cleaning Stainless Steel: Use a stainless steel cleaner product with a soft sponge
or cloth with a warm soap and water solution. Never use abrasive powders or
liquids.
• Cleaning the Burner Caps: Lift the burner caps from the burner heads and wash
them in a warm soap and water solution. Dry thoroughly before using them
again. Before reinstalling them on the burner head, check that the gas flow holes
are not clogged with food residues or cleaning products.
During cleaning operation, never move the appliance from its original
installation position. Never use abrasive cleaners! Scratches on the stainless
steel surfaces are permanent. Do NOT clean the range when hot!
WARNING
Disconnect the power before servicing the unit.
WARNING
Door does not lock during cleaning.
Use caution.
WARNING
• Cleaning Porcelain: Porcelain parts should be cleaned frequently with warm
soap and water solution applied with a soft sponge or wipe. Never use abrasive
powders or liquids! Do not leave acid or alkaline substances on the porcelain
parts (such as vinegar, lemon juice, salt, tomato sauce etc.) Use a rubber spatula
to remove fat residues.
• Cleaning Glass Door: Clean the glass using a non-abrasive sponge or wipe with
a warm soap and water solution. Use a rubber spatula to remove fat deposits.
Install the pins into slots on each hinge (pins not included.)
CHANGING DOORS
1. Open oven door and insert removal pins in door hinge. Close door half way.
Pull up and out on door to remove.
2. Uninstall the kick plate by unscrewing the four screws in the kick plate. There are
two at the top and bottom on each side. Have a helper tilt the range to unscrew
the bottom screws.
3. Remove kick plate.
4. Install new kick plate.
5. Reinstall the four previous screws from step 2.
6. Reinstall new oven door by reversing step 1. Place door hinges into slots of hinge
base receivers, keeping the door in half closed position. The door will drop into
the receiver base when proper engagement is achieved.
7. Open door to full open position slowly to verify proper operation. Remove hinge
pins.
MAINTENANCE AND CLEANING
Maintaining the Range
Changing Doors
Changing
doors video
SCAN ME
Loading ...
Loading ...