Loading ...
Loading ...
Loading ...
20
3. Set a 45 degree measuring device on the
table and against the fence, and tilt the
fence until it is flush against the device, and
therefore at a 45 degree angle.
4. Rotate the screw (H) until it contacts the
casting below it.
5. Tighten hex nut (H) and locking handle (C).
45 degree back stop:
1. Flip the stop block (D, Figure 29) out of the
way.
2. The 45 degree back stop is controlled by the
screw (J).
3. Loosen the locking handle (C) and the hex
nut on the screw (K).
4. Use an angle measuring device set at 45
degrees beyond the right angle (a total of
135 degrees) and place it on the table and
against the fence. Tilt the fence until it is
flush with the protractor.
5. Rotate the screw (J) to the proper height.
6. Tighten hex nut (K) and locking handle (C).
Loading ...
Loading ...
Loading ...