Loading ...
Loading ...
Loading ...
T,ewater,ispe.serw,,.otoperate,roper,y WATERFILTERCERTIFICATIONS
•Refrigerator connected to awater supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
•Kink in the water source line? Straighten the water source
line.
•New installation? Flush and fill the water system. See "Water
Dispenser."
•Is the water pressure at least 35 psi (241 kPa)? The water _,_om,,*_Modot_...........
pressure to the home determines the flow from the dispenser. ...............
See "Water Supply Requirements." 4_,_(_,-7_o
• Water filter installed on the refrigerator? Remove filter and
operate dispenser. If water flow increases, the filter may be
clogged or incorrectly installed. Replace filter or reinstall it
correctly.
Refrigerator door closed completely? Close the door
firmly. If it does not close completely, see "The doors will not
close completely."
Recently removed the doors? Make sure the water
dispenser wire/tube assembly has been properly reconnected
at the bottom of the refrigerator door. See "Refrigerator
Doors."
S(a[_ _ol C_tldorr tla
tN partmenl of Heahh SvI_lccs
Water Treatment Device
Ccrh licate Nm_ber
03- t583
acement L emeets
lhe water t re_tme#t deyeels_)/Fsmo on mls c_ll_ care na e met me (oN{_ requirements pursuant to SectFon
116830 of the _4e_Jlb_nd Salty Code _0r lhe fo ow lg health re ate_ ¢o_nt S:
M croblo _qlca[ C_t_t_tml_anls a_d _rb)d)ty nor_fa_/Ra_it_ o_ic_ Qo_tam _a_lts
C_sl %bcqu_
Or _rl c Co_t at_ma_
PZ2_
•Reverse osmosis water filtration system connected to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
Water is leaking from the dispenser system
NOTE: One or two drops of water after dispensing is normal.
• Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
• New installation? Flush the water system. See "Water
Dispenser."
• Recently changed water filter? Flush the water system. See
"Water Dispenser."
• Water on the floor near the base grille? Make sure the
water dispenser tube connections are fully tightened. See
"Refrigerator Doors."
Water from the dispenser is warm
NOTE: Water from the dispenser is only chilled to 50°F (1O°C).
• New installation? Allow 24 hours after installation for the
water supply to cool completely.
• Recently dispensed large amount of water? Allow
24 hours for water supply to cool completely.
• Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
•Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
17
Loading ...
Loading ...
Loading ...